STN EN ISO 294-5
| Označenie: | STN EN ISO 294-5 |
| Platnosť: | Platná |
| Počet strán: | 18 |
| Jazyk: |
EN
|
| Listinná verzia: | 14,10€ |
| Elektronická verzia: |
a) Bez možnosti tlače, prenosu textu a obrázkov:
12,69€ b) Bez možnosti tlače, s prenosom textu a obrázkov: 14,10€ c) S možnosťou tlače, prenosu textu a obrázkov: 18,33€ |
| Slovenský názov: | Plasty. Vstrekovanie skúšobných telies z termoplastových materiálov. Časť 5: Príprava normalizovaných skúšobných telies na skúmanie anizotropie (ISO 294-5: 2017) |
| Anglický názov: | Plastics - Injection moulding of test specimens of thermoplastic materials - Part 5: Preparation of standard specimens for investigating anisotropy (ISO 294-5:2017) |
| Dátum vydania: | 01. 07. 2018 |
| Dátum zrušenia: | 01. 05. 2026 |
| ICS: | 83.080.20 |
| Triediaci znak: | 64 0210 |
| Úroveň zapracovania: | idt ISO 294-5:2017, idt EN ISO 294-5:2017 |
| Vestník: | 06/18 |
| Zmeny: | |
| Nahradzujúce normy: | STN EN ISO 294-5:2026-05 (64 0210) |
| Nahradené normy: | STN EN ISO 294-5:2013-09 (64 0210) |
| Poznámka vo Vestníku: | |
| Predmet normy: | This document specifies a mould (designated the type F ISO mould) for the injection moulding of plates with a preferred size of 80 mm × 120 mm and a minimum size of 80 mm × ?90 mm and with a preferred thickness of 2 mm for single-point and multi-point data acquisition. It has been found to provide the maximum anisotropic properties, with only a slight sensitivity to the rate of injection. Whenever possible, a two cavity mould is intended to be used. For the design of plastic parts, this will provide upper and lower bounds for the tensile properties. Matching the plate thickness to a given part thickness is not a suitable criterion because of the effect of mould filling rate and part geometry on anisotropy. ... |
| Náhľad normy: | Náhľad normy (PDF) |