STN EN ISO 294-5
| Name: | STN EN ISO 294-5 |
| Validity: | Valid |
| Number of pages: | 18 |
| Language: |
EN
|
| Paper: | 14,10€ |
| Electronic version |
a) Only read (without ability to print and copy)
12,69€ b) Without ability to print, with ability to copy (printscreen) 14,10€ c) With ability to print and copy (printscreen) 18,33€ |
| Slovak title | Plasty. Vstrekovanie skúšobných telies z termoplastových materiálov. Časť 5: Príprava normalizovaných skúšobných telies na skúmanie anizotropie (ISO 294-5: 2017) |
| English title | Plastics - Injection moulding of test specimens of thermoplastic materials - Part 5: Preparation of standard specimens for investigating anisotropy (ISO 294-5:2017) |
| Release Date: | 01. 07. 2018 |
| Date of withdrawal: | 01. 05. 2026 |
| ICS: | 83.080.20 |
| Sorting character/National clasification code | 64 0210 |
| Level of incorporation: | idt ISO 294-5:2017, idt EN ISO 294-5:2017 |
| Official Journal | 06/18 |
| Amendments | |
| Replaced by: | STN EN ISO 294-5:2026-05 (64 0210) |
| Repleces: | STN EN ISO 294-5:2013-09 (64 0210) |
| Note in Official Journal: | |
| Subject of the standard: | This document specifies a mould (designated the type F ISO mould) for the injection moulding of plates with a preferred size of 80 mm × 120 mm and a minimum size of 80 mm × ?90 mm and with a preferred thickness of 2 mm for single-point and multi-point data acquisition. It has been found to provide the maximum anisotropic properties, with only a slight sensitivity to the rate of injection. Whenever possible, a two cavity mould is intended to be used. For the design of plastic parts, this will provide upper and lower bounds for the tensile properties. Matching the plate thickness to a given part thickness is not a suitable criterion because of the effect of mould filling rate and part geometry on anisotropy. ... |
| Preview: | Náhľad normy (PDF) |