STN EN ISO 3506-3
| Name: | STN EN ISO 3506-3 |
| Validity: | Valid |
| Number of pages: | 24 |
| Language: |
EN
|
| Paper: | 14,10€ |
| Electronic version |
a) Only read (without ability to print and copy)
12,69€ b) Without ability to print, with ability to copy (printscreen) 14,10€ c) With ability to print and copy (printscreen) 18,33€ |
| Slovak title | Spojovacie súčiastky. Mechanické vlastnosti spojovacích súčiastok z ocelí odolných proti korózii. Časť 3: Nastavovacie skrutky (a podobné spojovacie súčiastky nenamáhané ťahom) so stanovenými triedami ocele a triedami tvrdosti (ISO 3506-3: 2025) |
| English title | Fasteners - Mechanical properties of corrosion resistant stainless steel fasteners - Part 3: Set screws (and similar fasteners not under tensile stress) with specified grades and hardness classes (ISO 3506-3:2025) |
| Release Date: | 01. 04. 2025 |
| Date of withdrawal: | |
| ICS: | 21.060.10 |
| Sorting character/National clasification code | 02 1007 |
| Level of incorporation: | idt EN ISO 3506-3:2025, idt ISO 3506-3:2025 |
| Official Journal | 03/25 |
| Amendments | |
| Replaced by: | |
| Repleces: | STN EN ISO 3506-3:2010-05 (02 1007) |
| Note in Official Journal: | |
| Subject of the standard: | This document specifies the mechanical and physical properties of set screws and similar fasteners not under tensile stress, made of corrosion resistant austenitic and duplex stainless steels, with specified grades and hardness classes. ISO 3506-6 provides general rules and additional technical information on suitable stainless steels and their properties (detailed properties of stainless steel grades, corrosion behaviour with regards to pitting, crevice and intergranular corrosion, magnetic properties, etc.). WARNING — Set screws conforming to the requirements of this document are tested at the ambient temperature range of 10 °C to 35 °C and are used in application ranging from –20 °C to +150 °C. It is possible that they do not retain the specified mechanical and physical properties at lower and/or elevated temperatures. Therefore, it is the responsibility of the user to determine the appropriate choices based on service environment conditions of the assembly (see also Clauses 5 and 6). This document ... |
| Preview: | Náhľad normy (PDF) |