TNI CEN/TR 17079
| Označenie: | TNI CEN/TR 17079 |
| Platnosť: | Platná |
| Počet strán: | 10 |
| Jazyk: |
EN
|
| Listinná verzia: | 9,70€ |
| Elektronická verzia: |
a) Bez možnosti tlače, prenosu textu a obrázkov:
8,73€ b) Bez možnosti tlače, s prenosom textu a obrázkov: 9,70€ c) S možnosťou tlače, prenosu textu a obrázkov: 12,61€ |
| Slovenský názov: | Navrhovanie kotvenia do betónu. Redundantné nenosné systémy |
| Anglický názov: | Design of fastenings for use in concrete - Redundant non-structural systems |
| Dátum vydania: | 01. 02. 2019 |
| Dátum zrušenia: | |
| ICS: | 21.060.01, 91.080.40 |
| Triediaci znak: | 73 1253 |
| Úroveň zapracovania: | idt CEN/TR 17079:2018 |
| Vestník: | 01/19 |
| Zmeny: | |
| Nahradzujúce normy: | |
| Nahradené normy: | |
| Poznámka vo Vestníku: | |
| Predmet normy: | 1.1 General This Technical Report provides design rules for fasteners used to connect statically indeterminate non-structural light weight systems (e.g. suspended ceilings, pipe work, ducting) to concrete members such as walls or floors (see Figure 1)). The proposed design model may be applied to post-installed mechanical and bonded anchors covered by EN 1992-4:2017, 1.2. Their suitability will be confirmed in a European Technical Product Specification. The design rules assume the following: - under extreme conditions (e.g. large crack width) excessive slip or failure of a fastener might occur; - elements or systems are attached with at least three fixing points with one or more fasteners at each fixing point; - where more than one fastener is used at a fixing point (MF, see Figure 1) |
| Náhľad normy: | Náhľad normy (PDF) |