STN EN ISO 8062-3
| Name: | STN EN ISO 8062-3 |
| Validity: | Valid |
| Number of pages: | 48 |
| Language: |
EN
Pripravuje sa preklad do slovenského jazyka. Pre viac informácií nás kontaktujte na navrhynoriem@normoff.gov.sk
|
| Paper: | 18,90€ |
| Electronic version |
a) Only read (without ability to print and copy)
17,01€ b) Without ability to print, with ability to copy (printscreen) 18,90€ c) With ability to print and copy (printscreen) 24,57€ |
| Slovak title | Geometrické špecifikácie výrobkov (GPS). Rozmery a geometrické tolerancie pre tvarované diely. Časť 3: Všeobecné rozmerové a geometrické tolerancie a prídavky na opracovanie pre odliatky s použitím tolerancií ± pre určené rozmery (ISO 8062-3: 2023) |
| English title | Geometrical product specifications (GPS) - Dimensional and geometrical tolerances for moulded parts - Part 3: General dimensional and geometrical tolerances and machining allowances for castings using ± tolerances for indicated dimensions (ISO 8062-3: 2023) |
| Release Date: | 01. 06. 2023 |
| Date of withdrawal: | 01. 08. 2024 |
| ICS: | 17.040.10 |
| Sorting character/National clasification code | 01 4470 |
| Level of incorporation: | idt EN ISO 8062-3:2023, idt ISO 8062-3:2023 |
| Official Journal | 05/23 |
| Amendments | |
| Replaced by: | STN EN ISO 8062-3:2024-08 (01 4470) |
| Repleces: | STN EN ISO 8062-3:2007-12 (01 4470) |
| Note in Official Journal: | |
| Subject of the standard: | This document specifies general dimensional and geometrical tolerances as well as machining allowance grades for castings using ± tolerances for indicated dimensions as delivered to the purchaser according to ISO/TS 8062-2. It is applicable for tolerancing of dimensions and geometry of castings in all cast metals and their alloys produced by various casting manufacturing processes. This document does not apply to 3D CAD models used without indicated dimensions. This document applies to both general dimensional and general geometrical tolerances (referred to in or near the title block of the drawing), unless otherwise specified and where specifically referred to on the drawing by one of the references in Clause 11. The dimensional tolerances covered by this document are tolerances for linear dimensions. |
| Preview: | Náhľad normy (PDF) |